A. Getting to Know the App Interface
A quick look at your home screen. This overview explains the icons and buttons you'll use to monitor your WYBOT S3 and manage your pool cleaning cycles.
• Pair your WYBOT S3 while docked on the charging station.
• Connect to Wi-Fi for advanced features like mapping and scheduling.
• Configure pool settings to match your layout.
• Do not relocate the dock after mapping is completed.
B. Best Place to Place Your WYBOT S3
Best placement: Recommended starting positions for optimal cleaning coverage.
Acceptable placement: The robot can operate normally, but coverage may be reduced.
Notes
• The dock position is critical for cleaning performance.
• You may need to adjust the dock position.
• Pool shapes shown may not cover all designs.
• Contact support if unsure.
• Solar panel performs best under direct sunlight.
• Shadows may reduce charging efficiency.
C. Best Running Environment in the Pool
• Do not run filtration system while cleaning.
• Avoid using robot immediately after adding water.
• Do not place dock in water depth below 1.2m.
• Avoid pools with steps or ledges.
D. Best Pool Cleaning Procedure
• Use 380μm filter when opening pool or with heavy debris.
• Use 180μm filter for daily maintenance.
• Ultra-fine filter is for fine debris only.
• Not recommended for heavily soiled pools.
E. FAQ
1. Why does my robot not build a pool map?
Ensure Wi-Fi connection and stable dock connection during mapping. Contact support if needed.
2. Why does the map not accurately reflect my pool?
Ensure stable connection. Mapping improves over time.
3. Why does the robot not clean well in tile pools?
Tile surfaces can be slippery. This affects climbing ability, not a defect.
4. Why does the robot not fully collect debris?
Large debris may block suction. Clean filter basket manually.
5. Why does the robot not start on schedule?
Battery may be low or Wi-Fi disconnected.
6. Why does the dock not charge on a sunny day?
Dock charges itself first, then robot after reaching ~80%.
7. Why does water flow back after self-cleaning?
Adjust bottom screws or install collector tray.
8. Why is the pool map missing after re-pairing?
Use “Remapping” to generate a new map. Use "Share Robot" for multi-device viewing.
